Job Description SUMMARY: Tends fabricating machines such as saws, punches, elus, and CNCs; that cut, punch, and fabricate extrusions to form industrial doors and frames by performing the following duties. ESSENTIAL DUTIES AND RESPONSIBILITIES include but are not limited to the following: Adhere to all Kawneer rules and regulations. Identifies material by part number and product finish. Loads and unloads materials onto or from pallets, trays, racks, shelves and machinery by hand. Reads and interprets take-off sheets, cut lists, templates, D-ops, and shop orders to determine machine setup and sequence of operation. Operate saw, end mills, and elus. Sand, clean and mark proper identification on all jobs. Knowledge and ability to follow the MDR scrap material process. Cleans work area, machines, and equipment. Performs quality inspections and reports errors. Complete checklists, reports, and logs as needed. Flexible to work in other areas of the plant. Effectively problem solves, and engages in ABS activities. Qualifications BASIC QUALIFICATIONS: High school diploma or general education degree (GED) required. PREFERRED QUALIFICATIONS: One to six months related work experience is preferred. Ability to read, analyzes, and interprets documents such as, operating and maintenance instructions, safety rules and procedure manuals. Ability to write routine reports and correspondents. Ability to effectively communicate with other employees and supervisors. Ability to count, to add, to subtract and to multiply simple numbers. Ability to apply common sense understanding to carry out instructions furnished in written, oral, or diagram form. Ability to deal with and respond to minor problems in standard work situations. Able to measure to 1/32 of an inch.