welding | Pipe Fitters for Night Shift in Port Allen, LA Pipe Fab Shop in Port Allen, LA

Pipe Fitters for Night Shift in Port Allen, LA Pipe Fab Shop

  • Turner Industries Group, L.L.C.
  • $63,526.67 - 141,140.00 / Year *
  • 7598 LA-76
  • Port Allen, LA 70767
  • Full-Time
save job button



Job Description: Works under the direction of a foreman, interprets shop sketches identifies material listed and fabricates pipe spools


Functional Requirements:
Read and sign off on JSA; gather materials listed on sketch to fabricate table, record heat numbers from fittings to the sketch if required, lay out for outside diameter nozzle attachments, prep pipe and fittings with pneumatic grinders for fit up, use a plasma or oxy fuel torch, clean out inside diameter with compressed air after fit-up, math skills required to add and subtract dimensions, figure inside/outside arc of shells, figure outside diameter rolls for spool orientation such as attachments, flange, two holes, maintains a clean work area

Qualification Standards:

MUST HAVE SHOP PIPE FABRICATION EXPERIENCE

Preferably one (1) to four (4) years of experience in specified skill in a FAB SHOP SETTING
Pre-employment on-site qualification test
Post-offer drug/alcohol screen and physical evaluation

OSHA approved corrective eye wear (Z87)
Job site 'Personal Protective Equipment' requirements (hearing protection, safety glasses, long sleeve shirt, gloves, steel toe boots, etc)

Physical Involvement:
Employee may be required to do the following: climbing ladders, scaffolds, structures, etc. above and below ground level; maintaining balance on ladders, scaffolds, structures, etc.; reaching in all directions, handling and manipulating objects and materials; coordinating the movements of eyes, hands and fingers to operate tools and equipment; lifting 30 to 50 pounds from ground level, waist level, and/or overhead; carrying objects, tools equipment, etc.; standing; sitting; walking; pushing; pulling; bending; kneeling; crouching/squatting; crawling; seeing with or without correction; hearing with or without correction

Mental Involvement:
Employee may be required to do the following: following set procedures and standards; applying basic mathematical skills; planning work and selecting proper tools; reading and interpreting load charts; judging distances and slopes accurately; following oral and/or written directions; reading; writing; ability to recognize and report safety hazards

Work Environment Factors:
Location: industrial construction sites and/or fabrication shop
Mobility Barriers to Access Job Site: uneven ground levels; obstructed pathways; work performed at low and/or high elevations; work performed in confined areas

Climatic/Environmental Conditions at Job Site:Outdoor climate;Exposed to extreme hot or cold weather, excessive humidity, rain, etc.; various noise levels caused by tools, machinery, equipment, etc.; potential exposure to chemical substances

Miscellaneous Requirements:
There will be times that the individual may be required to perform a task other than their normal operation as required by the company or the foreman, owing to the job demand.



Associated topics: aluminum, arc welding, carbon, composites, fusion, general fabricating, metal, mig, torch cutter, wave machine


* The salary listed in the header is an estimate based on salary data for similar jobs in the same area. Salary or compensation data found in the job description is accurate.